I continue to design and build DIY projects for Digital Trends, and this is one of my new faves. It’s a great-looking, super-functional rack for your collection of vinyl records, which also happens to be totally easy to build. The how-to video is up now, and here are some of the highlights.
The four parts of the rack are held together with simple notches, which are so sturdy on their own that you don’t have to nail the fit of each one and they don’t have to be glued. That means you can cut them with a wide variety of tools, by hand with a coping saw, or by power with a jigsaw or bandsaw. If you’ve got one, I believe a dado set would do the tidiest job, but it’s not necessary.
I found one gorgeous 10-in.-wide jatoba board at my local hardwood shop, and cut all the parts from that. You’ll need about 60 in. of length, and a 1-in.-thick board will look better than 3/4, though it’s all good. You don’t even have to nail the dimensions, but the 10 degree angle in the feet and the splay of the sides is pretty close to perfect I think.
Here’s a PDF with the angles and dimensions I used: Record rack dwg
You’ll need a tablesaw to cut all the parts to width cleanly, though you could do it with other tools. Another option is to ask your lumber dealer to cut up the board to the lengths and widths you need.
After that, there are a couple of really cool tricks for laying out the notches. Start by chopping the feet to that 10-degree angle on the ends. I used a miter saw for that. After penciling in some tick marks for where the notches begin, you can use the end of one foot to lay out the notches in the other! Just lay one foot atop the other, reversing the angle of the end to create the same 10-degree angle in the other direction.
To get the other side of the notch, there’s another simple trick. Lay the foot on edge on that first line and trace its other side.
In other words, you are using the actual boards themselves to lay out notches that will fit them. The notches in the tall sides are square, so laying those out is easier, but still use the feet on edge to lay out the second side of each one.
After that I used a jigsaw to cut along the inside of each straight pencil line, and then made curving cuts to remove the waste piece between them. Then I sanded the whole project to 220 grit, broke the edges lightly with 150-grit paper on a block, and applied two coats of Minwax Teak Oil, rubbing each dried coat with a brown paper bag to burnish it–another great trick. As you can see, jatoba takes a beautiful polish.