I first saw this project at Maker Flat, a Portland B&B created by Bryan Danger and filled with handcrafted furniture and accessories. On the front deck was this awesome sign with the house number formed by screws, acting as pixels of a sort. I was blown away and decided right then to both make one for my house and to put a picture of Bryan’s sign in my next book (chock full of maker projects, coming out in fall 2018).
Since the book only contains a picture of Bryan’s sign, with no how-to, here is the step-by-step for creating one like mine. You can do it all with a cordless drill, but it helps a lot to have a drill press for the pilot holes, so each screw goes in perfectly square and the sign ends up looking very uniform.
Also, I used about 6 lbs. of 2-1/2-in.-long stainless steel screws, which aren’t cheap. You want stainless steel, which won’t rust or tarnish outdoors. I drove them into a cedar decking plank, which will weather to a nice gray. But you could use other outdoor woods for your sign, like white oak, teak or ipé, and put a finish on them to preserve the color if you want. Personally, I’ll enjoy the contrast between weathered wood and the shiny screws.
I also took advantage of a sweet Woodpecker’s T-square for laying out the grid, though a normal square and tape measure would work too. Read on for all of the steps and tricks.
We love the finished sign, and visitors always stop to give it a close look. “Gorgeous,” one said recently. Music to my ears.